Set Up Your Pool

Leave your pool's filter and heater operating normally. Do not use your pool or spa during test period. Turn off all automatic-filling systems. Turn off all water features such as waterfalls, fountains, spa spillways or spray heads that produce excessive evaporation.

Fill your pool to its normal operating level. Over filling the pool may give an indication of a false leak.

Select Location

Check A Leak is designed to work on the first or second step of your pool.

If the water depth at the top step is over 4" you can place the Check A Leak on the top step without the legs. If the water depth at the top step is under 4" you must attach the legs and place the Check A Leak on the second step.

Attach Legs If Needed

Place short legs over the leg post. 

Twist legs to lock in place. 

Add leg extensions if needed.

Add Water

Fill Check A Leak with water to 1 1/2" below the top of the center tube. (Between 14 & 16 on the outside gauge)

Place Unit

Place unit on the top or second step. 

When using the second step. Adjust the leg height so that the level inside the unit 1" above the pool water level.

This will give Check A Leak weight and stability.

Add Gauge & Float

Insert the Leak Gauge into the center tube then place the blue float over the Leak Gauge and center tube.

Make sure both floats are floating freely.

Check A Leak is designed to respond slowly to changes in conditions. You must wait at least 15 minutes for the floats to stabilize before recording the starting reading.

Record The Reading

24 hours later record any change in the reading

You can call 1-877-IT-LEAKS (877-485-3257) to locate the nearest Check A Leak Systems dealer in your area.

P.O. Box 1776
Arcadia, Florida 34266
Phone: 863-494-4966

Main Page  II  Info  II  Products  II  Contact Us

©2000 Check A Leak™
All Rights Reserved